Drive XLR8 Herbicide Crabgrass Killer - Questions & Answers

Displaying 21 to 40 (of 282 questions)
Sort:
  • Asked by Blaine from Longview, Tx
    05/08/2018
    Q
    What is the difference between spot sraying and broadcast spraying? And isn't the mixture for both the same?
    A

    Spot spraying means that you are treating individual weeds directly, or in "spots," rather than applying a product to the entire lawn.  Broadcast spraying refers to applying a product to the entire area.  The mix rate for Drive XLR8 Herbicide Crabgrass Killer would be the same whether spot spraying or broadcast spraying. 

    Was this answer helpful to you?   Yes No
    28 of 30 people found this answer helpful.
  • Asked by Ran from Burke, Va (subarb Of Washington, Dc)
    05/10/2014
    Q
    How long can I keep the solution (Drive XLR8, DyneAmic, Water) for reuse?
    How long can the mixture of Drive XLR8 (3 Tablespoons), DyneAmic (1.5 Tablespoons), and Water (1 Gallon) be left in the tank for reuse? I want to mix the above and use it for spot spraying over crabgrass whenever new crabgrass grows.
    A
    You want to make sure to use the diluted solution within 24 hours of mixing. The shelf life in the original bottle is 3 years.
    Was this answer helpful to you?   Yes No
    27 of 32 people found this answer helpful.
  • Asked by Daniel from Chantilly, Va
    08/31/2016
    Q
    How much Drive XLR8 Herbicide Crabgrass Killer is needed for 25 gallons spot sprayer to treat Crabgrass in Tall Fescue lawn?
    A

    Drive XLR8 Herbicide Crabgrass Killer can be mixed at a rate of approx. 10 oz per 25 gallons water.

    Was this answer helpful to you?   Yes No
    27 of 36 people found this answer helpful.
  • Asked by Kenneth from Zellwood Florida
    09/22/2011
    Q
    Where can I find a crabgrass control as good as Asulox?
    A
    Our most popular crabgrass product is Drive XLR8. Drive XLR8 Herbicide is the latest technology in providing unsurpassed post-emergent crabgrass control. Drive XLR8 is a post emergent selective herbicide that is labeled for crabgrass as well many other troublesome weeds. Not for use on St Augustine grass.
    Was this answer helpful to you?   Yes No
    23 of 33 people found this answer helpful.
  • Asked by Jason from Eagan, Mn
    05/30/2012
    Q
    BASF recommends mixing Drive with a methylated seed oil to improve results. Do you carry that?
    A
    Our Dyneamic surfactant has methylated seed oil and is recommended to apply with Drive XLR8.
    Was this answer helpful to you?   Yes No
    23 of 27 people found this answer helpful.
  • Asked by Mbh from Central, Nj
    08/11/2018
    Q
    Can I apply Drive XLR8 if it is going to rain?
    A

    Drive XLR8 Herbicide Crabgrass Killer is best applied when rain is not expected within 24 hours after application.  After that time the amount of rainfall would not affect it.  

    Was this answer helpful to you?   Yes No
    23 of 25 people found this answer helpful.
  • Asked by John from Colbert, Georgia
    07/04/2019
    Q
    Can you use Drive XLR8 on Bermuda to kill crabgrass?
    A

    Yes, Drive XLR8 Herbicide Crabgrass Killer can be applied on Bermuda grass for crabgrass control. 

    Was this answer helpful to you?   Yes No
    19 of 19 people found this answer helpful.
  • Asked by Michael from Conway,sc
    06/01/2016
    Q
    What crabgrass killer is the best for centipede grass is Conway, SC in the 1st week of June?
    A

    As you probably know, Centipedegrass is a very sensitive species of turf so many products that eliminate the crabgrass and other weeds can also cause damage to your lawn. Hi Yield Atrazine is safe to be used on Centipede and it will suppress Crabgrass but may not completely eliminate it. It will also control a large variety of other broadleaf weeds. Tenacity is a great pre and post emergent herbicide that will control crabgrass along with many other types of weeds without harming your centipede lawn. Make sure to read the Tenacity label very carefully and mix exactly what is recommended as this is a strong product and mis-using it can cause temporary turf injury. When applying tenacity it is highly recommended to use a temporary turf colorant like Turf Mark Blue to allow you to see where you are spraying. Overlapping your application of Tenacity can cause temporary whitening of the lawn as well, but the color will return in 3-4 weeks at most. Please let us know if you have any other questions.

    Was this answer helpful to you?   Yes No
    18 of 23 people found this answer helpful.
  • Asked by Russel from Slinger, Wisconsin
    07/28/2017
    Q
    How long between rainfalls should I apply Drive XLR8 Herbicide?
    It rained recently and I will apply now. More rain is NOT in the forecast for several more days. Is that a problem.
    A

    Drive XLR8 Herbicide should be applied where there is no rain in the forecast for at least 24 hours. 

    Was this answer helpful to you?   Yes No
    18 of 21 people found this answer helpful.
  • Asked by Danny from Mount Vernon, Il
    08/10/2016
    Q
    Can I mix Drive XLR8 along with Gordon's Trimec when spraying my lawn?
    A

    Yes, Drive XLR8 Herbicide and Gordons Trimec can be mixed and sprayed together. Be sure to do a small tank mixture first to ensure there is no clumping between the two products. Also, be sure to use a methylated seed oil surfactant, such as Duo Stick, so that the weeds are killed more effectively. 

    Was this answer helpful to you?   Yes No
    18 of 18 people found this answer helpful.
  • Asked by Chevo from Burke, Va
    07/25/2016
    Q
    What is the max weather temperature for application of Drive XLR8 Herbicide?
    Q2: I have a 20 gallon tow-behind sprayer, and I need to cover my 1 acre fescue lawn. How much Drive XLR8 do I add to the 20 gallons of water?
    A

    Drive XLR8 Herbicide should not be used in temperatures above 80 degrees Fahrenheit. You will use 29 fl. oz. in 20 gallons of water. The rate is 1.45 fl. oz. per gallon of water.

    Was this answer helpful to you?   Yes No
    18 of 21 people found this answer helpful.
  • Asked by Diana from Gerrardstown Wv
    05/25/2014
    Q
    Can I use Drive XLR8 with a hose end sprayer?
    I have a large lawn, abut 20.000 sq.ft., quite a lot of crabgrass and broadleaf. How much product do I need?
    A

    Drive XLR8 is not recommended to be used in a hose end sprayer. 

    The first thing you need to know when using an herbicide such as Drive XLR8 Herbicide is that the exact amount of water you dilute it with is not important. It is only important to make sure you are using the correct amount of product per 1,000 sq ft of lawn. Use too much and you risk damaging your lawn, use too little and you will not get adequate results. You will need to use 1.45 oz per 1,000 sq ft . To decide how much water you want to use, you should mark a 1,000 sq ft area, fill your sprayer with water ONLY, and start walking and spraying just as if you were doing the actual application of herbicide. When you are done walking and spraying the 1,000 sq ft area note how much water it took you to spray that area, and that is the amount you will want to mix 1.45 oz of product with for each 1,000 sq ft area that needs to be treated. You will need to make sure treated areas are irrigated with at least 1/2 inch of water (either by rainfall or by sprinkler) following the application.
    Was this answer helpful to you?   Yes No
    17 of 22 people found this answer helpful.
  • Asked by Ron from Kingston Springs, Tn
    07/20/2017
    Q
    If the temperature is going to be in the 90's could Drive be applied early in the morning before it gets hot?
    A

    Yes, morning applications of Drive XLR8 Herbicide Crabgrass Killer are best in hotter weather as it should only be applied in temperatures below 85.

    Was this answer helpful to you?   Yes No
    16 of 21 people found this answer helpful.
  • Asked by Doug
    04/20/2019
    Q
    Can Drive XLR8 and Prodiamine 65 WDG
    A

    Yes, Drive XLR8 Herbicide Crabgrass Killer and Prodiamine 65 WDG can be tank mixed and applied at the same time.

    Was this answer helpful to you?   Yes No
    16 of 16 people found this answer helpful.
  • Asked by Howard from Atlanta, Ga
    06/24/2016
    Q
    Should the lawn be wet before or after applying Drive XLR8 Herbicide Crabgrass Killer?
    I wet my lawn well but do not know about 1/2 inch of water. I sprayed immediately after with the grass still wet I am concerned. How long will it take to see some or any results ?
    A

    Since Drive XLR8 Herbicide is a post-emergent herbicide, we want to make sure that we get good coverage of the target plants, and that the application has time to dry before rainfall or before the lawn is watered. Drive should not be watered-in upon application since we want it to stay on the surface of the target plants. Be sure you are using an appropriate surfactant when using Drive, such as Prime Source Duo Stick. You should allow 10-14 days to start seeing results from post-emergent herbicides.

    Was this answer helpful to you?   Yes No
    15 of 22 people found this answer helpful.
  • Asked by Robert from Auburn, Me
    09/01/2016
    Q
    How long after Drive XLR8 Herbicide Crabgrass Killer application before I can let my child (14mo) play in the treated area?
    A

    You can let your child re-enter the Drive XLR8 Herbicide Crabgrass Killer after the treated area has dried.  This can take at least 2 hours.

    Was this answer helpful to you?   Yes No
    15 of 15 people found this answer helpful.
  • Asked by Bill from Westport, Ct
    05/26/2014
    Q
    Is Drive XLR8 Herbicide Crabgrass Killer safe for pets
    A
    Drive XLR8 Herbicide Crabgrass Killer is safe for pets after the treated area has dried. Please be sure to follow the product label for application instructions.
    Was this answer helpful to you?   Yes No
    14 of 14 people found this answer helpful.
  • Asked by Cedric from Orange Park Fl.
    01/16/2020
    Q
    What herbicide kills crabgrass without killing St. Augustine?
    I have a mixture of grass and weeds in my back yard, and good St. Augustine grass in front yard. I want something that kills crabgrass, plus other weeds, without harm to St. Augustine grass.
    A

    Drive XLR8 is NOT for use in a St. Augustine lawn. Blindside Herbicide WDG is labeled for crabgrass, as well as many other weeds, and is safe to be used on St. Augustine. 

    Was this answer helpful to you?   Yes No
    14 of 20 people found this answer helpful.
  • Asked by Jean
    08/01/2013
    Q
    What products to kill: crabgrass, quackgrass, foxtails, purslane, plantain and clover in my lawn?
    Hi I am from Montreal, Canada. I have crabgrass, quack-grass, fox-tails, purslane, plantain and clover in my lawn. I have 21,000 square feet of lawn. I planned to use more than one time over the years. Witch products should I buy? And We are planned to go pick-up the products on August 12. Do have it in stock?
    A

    Drive XLR8 is a great post emergent product to treat all of the weeds you listed.  Please check the product label to ensure your turf will tolerate Drive XLR8.Yes, we do have these products in stock. You can always contact us at 866-581-7378 as well.

    Was this answer helpful to you?   Yes No
    13 of 13 people found this answer helpful.
  • Asked by Richard from Mooresville, Nc
    08/16/2019
    Q
    What is the best time of the year to apply Drive XLR8?
    Even with lawn company about 1 July crabgrass starts growing. Now mid August have very thick patches. It seems to be in same places every year. Charlotte nc.
    A

    When using Drive XLR8 Herbicide Crabgrass Killer for crabgrass, it’s best to apply at either the very young stage or the most mature stage of the crabgrass.  When treating between the 2-4 tiller stage, repeat application may be required.  You should make your applications while temperatures are between 65 and 85 degrees for best results.  You can also use a pre-emergent like Dimension 2EW in the spring and the fall to help prevent it from coming up the following season.

    Was this answer helpful to you?   Yes No
    13 of 15 people found this answer helpful.
Displaying 21 to 40 (of 282 questions)