Areas that have been treated with Glystar Plus are safe to water 24 hours after application.
Yes, Glystar Plus would kill tall fescue. It is nonselective so it will kill whatever it is applied to.
Glystar Plus is mixed at the rate of 1 to 5 pints per acre in 10 to 40 gallons of water per acre as a broadcast spray unless specified depending on the target weed according to the product label. Water is just the carrier so is not set and is however much water it takes to cover the treatment area.
Yes, Glystar Plus is labeled for kudzu. The product label does state that for complete control, repeat applications may be required.
For best results Glystar Plus should be stored at or near room temperature. If it became frozen for any length of time, we recommend that you purchase a new product.
GlyStar Plus herbicide contains glyphosate, which is a non-selective herbicide. You can use this to spot treat unwanted plants very carefully around your trees and flower beds, just be sure that you do not contact the desirable plants through direct spray or drift.
Glystar Plus is mixed at the rate of 1 to 5 pints per acre in 10 to 40 gallons of water per acre as a broadcast spray unless specified depending on the target weed according to the product label. Mixing stronger will not make it work better: this could cause resistance in areas where the same plants are treated many times with this or other glyphosate products.
Glystar Plus is a non selective glyphosate based contact kill only to the weeds that are sprayed directly. There is no residual control.
Keep your chickens out of the area while you are making a Glystar Plus application and let it all completely dry before they can roam free again.
La tasa de mezcla de Glystar Plus dependerá de dónde y a qué malezas se dirige. Consulte la tabla de contenido en la página 2 de la etiqueta del producto como referencia.
*Translation: The mixing rate for Glystar Plus will depend on where and what weeds you are targeting. Please refer to the Table of Contents on page 2 of the product label for reference.
Glystar Plus should be applied when temperatures are between 65-85 degrees for best results. Extremely cool or cloudy weather following treatment my slow activity and reduce visible results. Weed control should appear within 2-4 days but can take up to 7 + days for perennial weeds.
Please view the full product label for more information.
You should avoid applying Glystar Plus to foliage, green stems, exposed roots or fruit or crops, desirable plants and trees.
Glystar Plus is labeled for residential use. Please refer to the product label for complete instructions.
Glystar Plus is labeled for cattails. Please be sure to review the product label for more information and complete application instructions.
NOTE: This is a product that we no longer carry as it has been discontinued.
Glystar Plus is mixed at the rate of 1 to 5 pints per acre in 10 to 40 gallons of water per acre unless otherwise specified depending on the target weed according to the product label. Water is just the carrier so is not set and is however much water it takes to cover the treatment area.
For smaller volume applications, refer to the 7.3 Table Rate Chart for Mixing in Hand Held Sprayers on the product label.
