As long as MSM Turf Herbicide was used at the rate of 1 2/3 ounces or less per acre, there are no grazing restriction on pastures. We would recommend they be out of the area during treatment until dry, typically 4-6 hours just to be safe.
Per the product label: To maintain flexibility in crop rotation plans, do not treat your entire pasture, rangeland or CRP acreage with this product at the same timeRhodes grass (chloris gayana ) is not on the MSM Turf Herbicide product label to be controlled.
The product label of MSM does not mention that MSM and Image have been tested for tank mixes. It does state: "Tank mixes with other registered herbicides and MSM Turf Herbicide should be tested for compatibility before full scale mixing. Use mechanical or bypass agitation to thoroughly mix the spray suspension. It is not necessary to premix this product with water in a separate container prior to adding it to the spray tank. This product should always be added to the tank first, before any other herbicides or adjuvants." Keep in mind that MSM has extremely low application rates and is very difficult to apply to small areas.
A great option to treat both nutsedge and spurge would be a sulfentrazone product such as Sulfentrazone 4SC. This product is safe on most turfgrasses and has very low use rates.
You could potentially apply MSM Turf Herbicide if the centipede is completely dormant. Be sure that the target weeds are actively growing for best results. Please refer to the product label for complete application directions.
MSM Turf Herbicide is labled to control spurge on certain turfgrasses. Please review the the product label for complete application instructions. Keep in mind that this product is best used on larger areas since it cannot be measured easily for small applications. Please let us know if you need a recommendation for your turf type and size lawn.
MSM Turf Herbicide is not labeled for spiderwort. If you would like to share more about where you are needing to treat, then we may be able to recommend an appropriate product for you.
Although MSM Turf Herbicide does not list it as a targeted species on the label, it should not be applied to/near michelia figo as injury/death could occur.
MSM Turf Herbicide is labeled to be applied at water volumes of 20 to 80 gallons of water per acre and pressures of 25-35 psi, so using only 15 gallons of water would not give you adequate volume for that size of an area. On Centipedegrass, you can apply 0.25 - 0.5 oz of MSM Herbicide per Acre.
MSM Turf Herbicide is not labeled to control goosegrass. Sulfentrazone 4SC is labeled for goosegrass and is safe for most kinds of turfgrass. Please let us know what kind of turfgrass you have and how large of an area you are treating for more specific recommendations.
You can apply MSM during dormancy or after complete green-up of the Bermuda lawn in the spring. You don’t want to apply any weed controls to the lawn during spring green-up since this is when the grass is in its most fragile state.
We would advise that you wait to apply MSM Turf Herbicide until the grass has came out of dormancy.
No, MSM Turf Herbicide should only be applied to listed turf areas, and not in flower beds. You can refer to the product label for listed turf areas and for complete application instructions. For control of broadleaf weeds around flowers, you usually will need to hand pull or spot treat carefully using a non-selective herbicide.
MSM Turf Herbicide does list spurweed as a target weed on the product label, which is sometimes referred to as burweed. Please be advised that proper weed identification is important, so you may want to check with your local extension office if you are in doubt.
Quali-Pro MSM Turf Herbicide is applied at 0.25-1.0 oz per acre depending on your turfgrass and the weeds you are targeting specifically. Please view the rates for Weeds Controlled and additional information depending on the turfgrass starting on page 8 of the product label. Use spray volumes of 20 to 80 galons of water per acre and pressures of 25 to 35 psi,
Quali-Pro MSM Turf Herbicide is not labeled for burr weeds of any kind. You may want to look at a product like Trimec Classic, which lists several burr weeds on the product label.
According to the product label of Quali-Pro MSM Turf Herbicide, there are NO restrictions regarding cutting hay after the applicaiton. The product label states: "GRAZING AND HAYING RESTRICTIONS: NONE. However, coveralls and shoes plus socks must be worn if cutting within 4 hours of treatment." Please be sure to review the product label for more information and complete application instructions.
MSM Turf Herbicide should be mixed with a nonionic surfactant. Otherwise, if you plan to tank-mix with another herbicide, then be sure you do a small jar test for compatibility first. I would also spot treat a small area of grass for tolerance since the turf will be more stressed in summer.
We recommend to apply Quali-Pro MSM Turf Herbicide at least 15 ft. away from any edibles and avoid any areas where there might be run off to the garden area.
MSM Turf Herbicide can be applied at 0.25 - 0.33 oz per Acre to treat spurweed. This would be safe on St. Augustine or Bermudagrass. You can view the full product label here.
If the lawn is very heavily infested, then you may consider clearing areas with a non-selective herbicide instead and putting in new seed or sod since it will be difficult to revive areas that have very weak turf.
