Elumin Fungicide

DIRECTIONS FOR USE

It is a violation of Federal law to use this product in a manner inconsistent with its labeling.

READ ENTIRE LABEL. USE STRICTLY IN ACCORDANCE WITH PRECAUTIONARY STATEMENTS AND DIRECTIONS, AND WITH APPLICABLE STATE AND FEDERAL REGULATIONS.

Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

APPLICATION INSTRUCTIONS

Always mix the product thoroughly before use.

SPRAYER PREPARATION

Before applying Elumin Fungicide, start with clean, well-maintained application equipment. The spray tank, hoses, and booms must be cleaned to ensure no residue from the previous spraying operation remains in the sprayer. The spray equipment must be cleaned according to the manufacturer’s directions for the last product used before the equipment is used to apply Elumin Fungicide. If two or more products were tank mixed prior to Elumin Fungicide application, follow the most restrictive cleanup procedure.

MIXING INSTRUCTIONS

1. Fill clean spray or nurse tank 1/2 to 2/3 of the desired level with clean water
2. While agitating, slowly add the Elumin Fungicide to the tank. Adequate agitation will create a rippling or rolling action on the water surface.
3. When tank mixing Elumin Fungicide with other labeled pesticides, add water-soluble packets first, followed by dry formulations, flowable, emulsifiable concentrates and then solutions. When tank mixing, follow the most restrictive label directions, precautions, and limitations.
4. Add any required adjuvants.
5. Fill tank to the desired level with the water. Continue to agitate until all spray solution has been used or applied.

SPECIFIC REQUIREMENTS – ALL CROPS

When to Apply: See crop-specific requirements. When applying as a foliar spray, apply in sufficient water to obtain thorough coverage. Chemigation is not recommended when the primary disease is downy mildew or other foliar diseases.

Resistance Management: Elumin Fungicide must be used as part of an integrated pest management (IPM) program. Observe the recommendations listed in the RESISTANCE MANAGEMENT section.

Restrictions and Limitations

• The maximum Elumin Fungicide application rate is 8 fl oz per acre per application and 16 fl oz per acre per year.
• If noted in the CROP SPECIFIC REQUIREMENTS section, do not apply sequentially before rotating to a nonGroup 22 fungicide that is registered for the same use and that is effective against the pathogens of concern.
• Do not make more than 2 applications of Elumin Fungicide per acre per year.
• Do not apply to greenhouse food crops.
• Do not apply this product when weather conditions favor spray drift from treated areas.
• When applying by air, observe drift management restrictions and precautions listed in the AERIAL APPLICATION section. The best control is achieved through a ground application.

CROPS

• Cucurbit Vegetables (Crop Group 9)
  • 2 days
  • 8 (0.25 lb ai/A)
  • 2 years
  • 16 (0.5 lb ai/A)
• Ginseng
  • 14 days
  • 8 (0.25 lb ai/A)
  • 2 years
  • 16 (0.5 lb ai/A)
• Pepper/Eggplant (Crop Subgroup 8-10B)
  • 2 days
  • 8 (0.25 lb ai/A)
  • 2 years
  • 16 (0.5 lb ai/A)
• Tuberous and Corm Vegetables (Crop Subgroup 1C)
  • N/A
  • 8 (0.25 lb ai/A)
  • 2 years
  • 16 (0.5 lb ai/A)