Remedy Ultra Herbicide is labeled for use on locust trees and you can do either the blanket spray to the actively growing areas, or a root drenching type spray to them after being cut with mowers. There are a couple of applications instructions on the Product Label you can follow which we have copied for you below.
Foliage Treatment with Ground Equipment: Use sufficient spray volume to completely and uniformly cover foliage. For ground application, apply 10 gallons or more of total spray volume per acre. Use higher spray volumes fo ground applications to ensure adequate coverage with increased depth and density of foliage, particularly for treatment of woody plants.
High Volume Foliage Treatment: For control of susceptible woody plants, use Remedy Ultra alone or in tank mix combination at the recommended rate to make 100 gallons of spray mixture. On rangeland and permanent pasture sites, make 1 application per year and apply no more than 2 quarts of Remedy Ultra per acre. To control a broader spectrum of woody plants and broadleaf weeds, Remedy Ultra may be tank mixed with other herbicides at recommended rates. Used alone- 1-2 qt Remedy Ultra per 1000 gallons of spray.
Dormant Stem Treatment: Mix 3 to 6 quarts of Remedy Ultra in enough oil to make 100 gallons of spray solution. Apply with a knapsack or power spraying equipment, using low pressure (20-40 psi). Treat anytime when brush is dormant and most of the foliage has dropped. Do not apply when snow or water prevent spraying to the ground line. Thoroughly wet the upper parts of the stems and use the remainder to wet the lower 12 to 15 inches above ground to the point of runoff. For root suckering species such as sumac, sassafras and locust, also spray the ground under the plant to cover small root suckers which may not be visible above the soil surface. For oil-water mixture application, mix 6 quarts of Remedy Ultra, 25 gallons of oil and 1.5 gallons of an approved agricultural spray emulsifier such as Sponto 712 or Triton X-100 as indicated on the mixing direction.
The rates for Remedy Ultra Herbicide will vary depending on where you are treating and what type(s) of weeds you need to treat. Please refer to the product label for complete application instructions.
Remedy Ultra Herbicide is not labeled to treat Woolly Croton. You need a product that has Dicamba in it, such as Hi Yield Range and Pasture Dicamba + D, which is labeled for Woolly Croton. Please read and follow the label instructions.
The active ingredient of Remedy Ultra Herbicide is triclopyr.
Remedy Ultra Herbicide is rainfast six hours after application.
The rates for Remedy Ultra Herbicide vary depending on where and how you are treating. Please refer to the product label for complete information on your application. For spot treatment, use a 1 to 1.5% solution of Remedy Ultra in water (1 to 1 1/2 gallons of Remedy Ultra in 100 gallons total spray mixture or 0.78 to 1.92 fl oz per gallon) and spray the entire plant to completely wet the foliage.
Remedy Ultra Herbicide is labeled for willows, however, it is not labeled to be used in or near ponds as it is toxic to fish and other aquatic life.
Hay cannot be harvested for 14 days following application of Remedy Ultra Herbicide. Except for lactating dairy animals, there are no grazing restrictions otherwise. Lactating dairy animals should not graze treated areas until the next growing season.
Remedy Ultra Herbicide is not labeled to control bamboo, although many people will use products containing triclopyr in conjunction with bamboo labeled herbices to try and gain better control. You can use Round Up QuickPro at the highest listed usage rate to help eliminate bamboo. No matter what product you use when trying to control bamboo you need to cut the plant down level with the ground and then use the designated product at the highest rate or undiluted to paint/pour directly on the freshly cut surface. Bamboo roots run very deep so often you have to do multiple applications with a product and repeat the cutting and painting phase a few times to fully kill the plant.
It is recommended that you wait at least 3 weeks after applying Remedy Ultra Herbicide to replant or reseed in an area.
You will use 0.01 oz. of Remedy Ultra Herbicide per gallon of water for spot treating.
Remedy Ultra Herbicide is toxic to fish and should not be applied directly to water, to the areas where surface water is present, or to intertidal areas below the mean high water mark.
Per the product label for Remedy Ultra Herbicide,
Growing point and leaf base (crown) treament:
Prepare a 2% v/v solution of Remedy Ultra in diesel or fuel oil (13 fl oz of Remedy Ultra in 5 gallons of spray mixture).
Streamline Basal Bark Treatment:
To control or suppress susceptible woody plants, mix 25 to 30 gallons of Remedy Ultra with 10% penetrant such as Cidekick in enough oil to make 100 gallons of spray mixture. Streamline basal bark treatment are most effective on stems less than 4 inches in basal diameter. Apply with a backpack or knapsack sprayer using equipment which provides a directed straight stream spray. Apply the spray in a 2- to 3-inch wide band to one side of stems less than 3 inches in basal diameter. When the optimum amount of spray mixture is applied, the treated zone should widen to encircle the stem within approximately 30 minutes. Treat both sides of stems whic are 3 to 4 inches in basal diameter. Direct the spray at bark that is approximately 12 to 24 inches above gorund.
Oil - Water Emulsions:
Prepare oil-water emulsions using diesel fuel, fuel oil, or kerosene plus and emulsifier such as Sponto 712 or Triton X- 100. Use a jar test to check spray mix compaitbility before preparing oil-water emulsion sprays in the mixing tank.
Going by the label, it doesn't indicate to use both. Using both would consider to be an off label usage. It it recommended to follow the label and just using one or the other.
Remedy Ultra Herbicide is not labeled for buffelgrass.
Remedy Ultra Herbicide can be used with either water or diesel fuel depending on where and what you are treating. Please refer to the product label for complete application instructions.
Per the manufacturer, it is not recommended to use any wood that was treated with Remedy Ultra Herbicide to smoke food, or to burn any of the treated wood.
Remedy Ultra Herbicide contains the active ingredient triclopyr - 60.45%. It is not an insecticide and should be applied when bees are not foraging.
The rates for Remedy Ultra Herbicide can vary depending on where you are treating and what you are treating for. Please refer to the product label for specific instructions for your needs.
Remedy Ultra Herbicide states on the product label: Except for lactating dairy animals there are no grazing restrictions following applications of this product. Do not allow lactacting dairy animals to graze treated areas until the next growing season following application of this product. Slaughter restrictions: During the seasons of application, withdraw livestock from grazing treated grassed at least 3 days before slaughter.
Remedy Ultra Herbicide should not be used in or near water as it is toxic to fish and other aquatic life.
