The rates for Remedy Ultra Herbicide vary depending on where and how you are treating. Please refer to the product label for complete information on your application. For spot treatment, use a 1 to 1.5% solution of Remedy Ultra in water (1 to 1 1/2 gallons of Remedy Ultra in 100 gallons total spray mixture or 0.78 to 1.92 fl oz per gallon) and spray the entire plant to completely wet the foliage.
Remedy Ultra Herbicide is labeled for willows, however, it is not labeled to be used in or near ponds as it is toxic to fish and other aquatic life.
Hay cannot be harvested for 14 days following application of Remedy Ultra Herbicide. Except for lactating dairy animals, there are no grazing restrictions otherwise. Lactating dairy animals should not graze treated areas until the next growing season.
Remedy Ultra Herbicide is not labeled to control bamboo, although many people will use products containing triclopyr in conjunction with bamboo labeled herbices to try and gain better control. You can use Round Up QuickPro at the highest listed usage rate to help eliminate bamboo. No matter what product you use when trying to control bamboo you need to cut the plant down level with the ground and then use the designated product at the highest rate or undiluted to paint/pour directly on the freshly cut surface. Bamboo roots run very deep so often you have to do multiple applications with a product and repeat the cutting and painting phase a few times to fully kill the plant.
It is recommended that you wait at least 3 weeks after applying Remedy Ultra Herbicide to replant or reseed in an area.
You will use 0.01 oz. of Remedy Ultra Herbicide per gallon of water for spot treating.
Remedy Ultra Herbicide is toxic to fish and should not be applied directly to water, to the areas where surface water is present, or to intertidal areas below the mean high water mark.
Per the product label for Remedy Ultra Herbicide,
Growing point and leaf base (crown) treament:
Prepare a 2% v/v solution of Remedy Ultra in diesel or fuel oil (13 fl oz of Remedy Ultra in 5 gallons of spray mixture).
Streamline Basal Bark Treatment:
To control or suppress susceptible woody plants, mix 25 to 30 gallons of Remedy Ultra with 10% penetrant such as Cidekick in enough oil to make 100 gallons of spray mixture. Streamline basal bark treatment are most effective on stems less than 4 inches in basal diameter. Apply with a backpack or knapsack sprayer using equipment which provides a directed straight stream spray. Apply the spray in a 2- to 3-inch wide band to one side of stems less than 3 inches in basal diameter. When the optimum amount of spray mixture is applied, the treated zone should widen to encircle the stem within approximately 30 minutes. Treat both sides of stems whic are 3 to 4 inches in basal diameter. Direct the spray at bark that is approximately 12 to 24 inches above gorund.
Oil - Water Emulsions:
Prepare oil-water emulsions using diesel fuel, fuel oil, or kerosene plus and emulsifier such as Sponto 712 or Triton X- 100. Use a jar test to check spray mix compaitbility before preparing oil-water emulsion sprays in the mixing tank.
Going by the label, it doesn't indicate to use both. Using both would consider to be an off label usage. It it recommended to follow the label and just using one or the other.
Remedy Ultra Herbicide is not labeled for buffelgrass.
Remedy Ultra Herbicide can be used with either water or diesel fuel depending on where and what you are treating. Please refer to the product label for complete application instructions.
Per the manufacturer, it is not recommended to use any wood that was treated with Remedy Ultra Herbicide to smoke food, or to burn any of the treated wood.
Remedy Ultra Herbicide contains the active ingredient triclopyr - 60.45%. It is not an insecticide and should be applied when bees are not foraging.
The rates for Remedy Ultra Herbicide can vary depending on where you are treating and what you are treating for. Please refer to the product label for specific instructions for your needs.
Remedy Ultra Herbicide states on the product label: Except for lactating dairy animals there are no grazing restrictions following applications of this product. Do not allow lactacting dairy animals to graze treated areas until the next growing season following application of this product. Slaughter restrictions: During the seasons of application, withdraw livestock from grazing treated grassed at least 3 days before slaughter.
Remedy Ultra Herbicide should not be used in or near water as it is toxic to fish and other aquatic life.
Remedy Ultra Herbicide has a mild odor that will eventually dissipate.
Holly shrubs would need to be treated like trees, in which case you would cut the shrubs down to stumps and then treat the fresh cuts with Remedy Ultra Herbicide. For small volume applications, you would use 25-38.4 oz per gallon of water, being sure to get the outer layers and cambium of the stump. You will still need to remove the strumps and root systems physically after using herbicides to stop regrowth.
Remedy Ultra Herbicide is not labeled to control bamboo, it is best for woody and vine plants. You can use Round Up QuickPro at the highest listed usage rate to help eliminate bamboo. You will be required to cut the bamboo down to a short stump and then apply the Round Up QuickPro. It can take several applications to achieve the desired results. You should contact your local cooperative extension office and speak to the master gardener on staff to see if you will be required to till your yard or if you can seed and fertilize only.
Pendulum 3.3 and Remedy Ultra Herbicides can certainly be mixed together and applied at the same time. Keep in mind that Pendulum is a pre emergent and is normally only applied in spring and fall at specific times for your area to get the longest lasting result and prevent new weeds from coming up the next season. The Remedy since its a post emergent will need to be applied when the weeds and vines and target plants are still in an actively growing state to allow for the full effects of the product to take place. Remedy contains Triclopyr which is one of the top ingredients used for killing unwanted weeds and brush in pasture areas. Be sure to use a sufficient water volume to completely cover the target plants in product and to reduce the need for reapplication. Some trees/brush/viens may require a second application with Remedy if they are well established and mature in growth. On average you should be using 1-2 gallons of water per 1000 sq/ft and then mixing the correct amount of product per those labels into that water amount for the area.
Keep in mind the Pendulum is not labeled for use where animals graze.
The rates for Remedy Ultra Herbicide vary depending on where and how you are treating. Please refer to the product label for complete information on your application. For spot treatment use a 1 to 1.5% solution of Remedy Ultra in water (1 to 1 1/2 gallons of Remedy Ultra in 100 gallons total spray mixture (or 0.78 to 1.92 fl oz per gallon) and spray the entire plant to completely wet the foliage.
