Talstar P Professional Insecticide can safely be applied in and around homes with pets as long as it is used according to the product label. Please make sure your dog is out of the area during treatment until the product has had time to dry completely. At that time your pet can resume normal activity.
Talstar P (Talstar One) will only kill those bugs that contact a treated area and states on the product label it should not be used alone for effective eliminate of bed bugs. This residual can last up to 90 days inside along baseboard, cracks and crevices, etc. It will not prevent a reinfestation. Typically, one product will not do the job. That's why we offer our Bed Bug Kits which have multiple products that are used in different areas in the bedroom and that do different things. The kit is exactly the products that a professional company would use and charge you hundreds of dollars to apply. All of our kits come with full instructions on where to apply each product. We make it easy as possible for you to treat your own bed bug problem, and our kits have a very high success rate when used correctly.
We also have a helpful prevention guide here.
We recommend using 1 fl oz of Talstar P per gallon of water. Use 2 gallons of solution/1000 square feet, immediate irrigation of treated area with at least 0.25 inches of water following application to ensure efficacy of sub-surface pests such as,
but not limited to, Mole Crickets, is recommended.
Mole Cricket adults: Achieving acceptable control of adult mole crickets is difficult because preferred grass areas are subject to continuous invasion during the early spring by this extremely active stage. Applications should be made as late in the day as possible and should be watered in with up to 0.25 inches of water immediately after treatment. If the soil is not moist, then it is important to irrigate
before application to bring the mole crickets closer to the soil surface where contact with the insecticide will be maximized. Grass areas that receive pressure from adult mole crickets should be treated at peak egg hatch to ensure optimum control of subsequent nymph populations (see below).
Mole Cricket nymphs: Grass areas that received intense adult mole cricket pressure in the spring should be treated immediately prior to peak egg hatch. Optimal control is achieved at this time because young nymphs are more susceptible to insecticides and they are located near the soil surface where the insecticide is most concentrated. Control of larger, more damaging, nymphs later in the
year may require both higher application rates and more frequent applications to maintain acceptable control. Applications should be made as late in the day as possible and should be watered in with up to 0.25 inches of water immediately after treatment. If the soil is not moist, then it is important to irrigate before application to bring the mole crickets closer to the soil surface where contact with the insecticide will be maximized.
Talstar P is labeled for chiggers, fleas and ticks outdoors at 1 fl oz per gallon of water per 1,000 sq ft. Treatments for chiggers should begin in May and could need to continue through the summer as new chiggers move into the area. Treating the entire lawn is of little benefit because chiggers avoid direct sunlight and normally will not infest areas that are mowed or otherwise well maintained. Focus treatment on the unkempt areas of the lawn and lawn edge.
Yes, Talstar P is labeled to kill springtails.
We cannot sell Talstar P to New York, South Dakota or Connecticut due to restrictions and regulations within those states.